 |
| Select a flat watchmaker's stake larger than the movement
side diameter of the bushing. From the movement side (shown face
up in photo) push out the bushing. Sometimes this can be accomplished
by hand, but if a hammer needs to be used, BE VERY
GENTLE using only light taps (these parts are brass and can be distorted
with surprising ease). |
 |
| This picture shows the bushing driven flush with the
movement side of the plate. |
 |
| Here I show a special stake I made just for this purpose.
The diameter of the shaft is 1.0 mm and is used to drift the bushing out
completely. This stake would easily damage the bushing if it were
used to remove it entirely, that is why the flat stake is used to push
it this far. |
 |
| Only hand pressure should be required to push the
bushing out the rest of the way. |
